Bully AS-600 - Vehicle Body Style Group Diagram; Tools Needed

BEFORE INSTALLATION: Check your vehicle's body metal (rocker panel)
underneath to determine which group your vehicle's body belongs to.
(Refer to the application chart on the following page).
Follow the group instructions for your vehicle only.
* For applications that require drilling, please see page 11.
VEHICLE BODY STYLE GROUP DIAGRAM
English
TOOLS NEEDED:
WARNING :
* Before you start installing, read these instructions completely and
make sure you understand them.
* Do not install this product on your vehicle if the vehicle's body metal
is rusted or otherwise damaged.
* Before drilling any holes, be sure the area is clear of any obstacles,
such as fuel lines, brake lines, wire harnesses, A/C lines, etc.
Be careful not to damage the painted body area.
* Do not modify step or installation hardware. Use step only on vehicles
listed on application chart. Install aluminum steps following these
instructions only.
* Use steps to enter and exit vehicle only.
IMPORTANT: Bully assumes no liability for any damage or injury caused
by customer's failure to adhere to the warnings and the directions in
these instructions.
English
NOTE: AS-600S, and AS-600SB contains piece count for one step.
two steps will include 2x the pieces.
( x8 )
5/16" x 1 1/8"
Bolt
( x4 )
5/16" x 2"
Bolt
( x8 )
5/16" x 18
Nut
( x16 )
5/16"
Washer
( x8 )
Sheet Metal
Screw
( x4 )
"C" Shaped
Bracket
( x4 )
"U" Shaped
Spacer
( x4 )
Plastic Wedge
Spacer
MOUNTING HARDWARE LIST for one step:
MOUNTING HARDWARE for ram 09-18 models only:
2
3
• Phillips screw driver #2 (both long and short)
• Power drill, drill bits (1/8", 1/4", 3/8")
• Center punch
• Open end wrench
• Ratchet with socket
• Small round file
• Black marker
GROUP A
Flat Wall Flat Wall with Bent Angle
GROUP B
GROUP C
Inclined Wall
GROUP D & E
Wall with a Channel
NOTE: Drilling required. Follow the drilling instructions on page 11.
( x2 )
2.75"
Screw
( x2 )
M8 x 1.25
Nut
( x2 )
Spacer