Some models may need
flange to be bent down
as shown.
2.75" Bolt
(Supplement)
Mounting
Plate
Spacer
(Supplement)
Nut
(Supplement)
Metal Body
English
English
INSTALLATION INSTRUCTIONS FOR ram 09-18 models only : For applications that require hole to be drilled
10 11
1. Measure 2" from the bottom of the hole already drilled out and
1 1/16" from the edge and mark the spot.
2. Drill out the hole using a 11/32" drill bit.
3. Verify supplied screw fits thru the hole.
NOTE: Drilling required. Follow the drilling instructions on page 11.
To Next Page
Loading...