Bunn BX BREWER - Common Problems and Solutions

Coffee doesn’t come out
• Go thru Setup process again (see page 8).
• Close Lid.
• Rell Hot Water Tank if water evaporation
has occurred.
• Check Sprayhead holes.
Machine only partially brewED
• Rell Internal Hot Water Tank if water evaporation
has occurred.
• You may need to increase water if coee
grounds and lter absorbed some water.
Coffee is not staying hot
• Make sure Warmer Switch is ON.
Coffee is cold
• Plug in brewer.
• Turn on Tank Switch.
• Allow 15 minutes for water to heat.
Funnel is overflowing
• Use BUNN
®
paper lters.
You can order more lters at bunn.com
• Check to make sure Sprayhead is in place.
• If you brew decaf, ne grind or use soft water,
request a special ow restrictor sprayhead by
contacting BUNN at 800-352-BUNN.
Brewer makes rumbling noise
• This is normal while water is heating.
• Clean the Sprayhead Tube (see page 18).
PROBLEM & SOLUTION
23