To Next PageTo Next Page
Need help?Do you have a question about the Bunn CWT 15-APS and is the answer not in the manual?
General| Brand | Bunn |
|---|---|
| Model | CWT 15-APS |
| Category | Coffee Maker |
| Language | English |
Details electrical service requirements for Model 15 and Model 20 brewers.
Details electrical service for Model 35 3-phase brewers.
Details electrical service for 200/230V AC single phase brewers.
Lists requirements for CE certified models, including temperature and water jet cleaning.
Provides a step-by-step guide for connecting the brewer to electrical power safely.
Describes Model C as completely portable, requiring no attached plumbing.
Details plumbing connection requirements for various single brewer models.
Provides tubing recommendations and advises against saddle valves for installation.
Outlines the step-by-step process for connecting twin brewers to the water supply.
Reiterates Model C is portable and needs no plumbing.
Details plumbing requirements for early single brewer models like CTF and CWT.
Describes the procedure for connecting early twin brewers to the water supply.
Details the initial water filling and setup steps specifically for Model C.
Covers initial setup for various single brewer models, including water filling and brew cycles.
Instructions for twins to repeat steps 1-10 for the other side.
Explains how to increase or decrease batch sizes by interacting with the circuit board switches.
Provides guidance on adjusting the thermostat based on altitude for optimal water temperature.
Describes the function of the ON/LOWER switch for starting and stopping brewing.
Explains how to momentarily press the start switch to initiate a brew cycle.
Details the use of the flip lid for adding water, with important warnings.
Explains the master ON/OFF switch that powers the entire brewer.
Describes the function of the tank heater switches, affecting only the heating circuits.
Illustrates the switches found on later models of the brewer.
Illustrates the switches found on earlier models of the brewer.
Outlines the steps for inserting a filter, adding coffee, and starting the brew cycle.
Explains how to dispense hot water and its limitations.
Recommends using a damp cloth with mild detergent for cleaning surfaces.
Details how to clean sprayhead holes and use a deliming spring.
Describes how to remove and clean the faucet aerator.
Lists probable causes and remedies for the brew cycle failing to start.
Provides solutions for when the water is not reaching the desired temperature.
Addresses causes and remedies for inconsistent beverage levels.
Explains how to adjust brew volumes for consistent results.
Details causes and remedies for spitting or excessive steaming.
Covers issues related to sprayhead dripping and brewer leveling.
Addresses the cause of brew cycles starting when the ON/LOWER switch is turned on.
Explains factors contributing to a weak beverage, including filter, grind, and temperature.
Discusses funnel loading and sprayhead issues causing dry grounds.
