Bunn Single TF DBC User Manual

Page 29
PROGRAMMING THE BREWER (cont.)
SET PULSE BREW - ENTER TIMES
NOTE: The procedure to enter the PULSE BREW
function must be performed prior to following the
steps listed below.
1. Press and release YES. The display should now
read EASY PULSE SETUP.
2. Press and release NO. The display will read ENTER
TIMES?
3. Press YES to proceed. The display should now
read 1st ON TIME X:XX.
4. Using (-) and (+) set the amount of time the fl ow
of water into the funnel will be on.
5. When fi nished, press DONE. The display will now
read OFF TIMES: X:XX.
6. Using (-) and (+) set the amount of time the fl ow
of water into the funnel will be off.
7. When fi nished, press DONE. The display will now
read LAST ON: X.XX
8. Using (-) and (+) set the amount of time the water
will be on to complete the brew.
9. When fi nished, press DONE. The display will show
the three times just entered for that batch size. After
a 5 second delay, the display will read 3 BATCHES
DONE?
10. If other batch sizes need to be modifi ed, press
NO.
12. Press a different batch size and repeat steps 3
through 7. Repeat until all the desired batch sizes
are set.
13. When fi nished press YES in 3 BATCHES DONE?.
The display will then read DRIP TIME.
14. Press and release the ON/OFF switch located on
the front switch panel to exit the SET PULSE BREW
function and return to the MAIN SCREEN.
NOTE: Pressing the upper right hidden button before
reaching the fi nal setting screen exits the setup and
retains the old values.
SET PULSE BREW?
NO YES
ENTER TIMES?
NO YES
EASY PULSE SETUP
NO YES
1st ON TIME X:XX
(-) DONE (+)
OFF TIMES: X:XX
(-) DONE (+)
LAST ON: X.XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
EXIT TO
NEXT FUNCTION
SCREEN
EXIT TO
NEXT FUNCTION
SCREEN
5 SEC. DELAY
1st OFF LAST
XX.X XX.X XX.X
P3265
35879.1 071405

Bunn Single TF DBC Specifications

General

Brand	Bunn
Model	Single TF DBC
Category	Coffee Maker
Language	English