Need help?Do you have a question about the Bunn TU3 and is the answer not in the manual?
General| Model | TU3 |
|---|---|
| Capacity | 3 Gallons |
| Water Tank Capacity | 3 Gallons |
| Output | Up to 3 gallons per hour |
| Voltage | 120V |
| Category | Kitchen Appliances |
| Product Type | Coffee Brewer |
| Type | Coffee Maker |
| Material | Plastic |
| Brew Time | Approximately 10 minutes |
Critical safety instructions for operation and potential hazards.
Requirements for installation based on plumbing and food safety codes.
Identifies important warning labels on the equipment for user safety.
Details voltage, phase, and amperage requirements for brewer operation.
Step-by-step guide for safely connecting the brewer to the electrical supply.
Specifies required water pressure, line size, and fitting type for connection.
Instructions for connecting the brewer to the water supply line.
Procedures for filling the water tank and performing initial brew cycles.
Steps to adjust and set the correct dilution volumes for brewing.
Completing setup and preparing for the first batch of brewed tea.
Adjusting brew volume settings by increasing brew time.
Establishing a specific batch volume by setting brew time.
Enabling a feature to prevent unauthorized changes to brew time settings.
Instructions for connecting the sweetener bag-in-box system.
Describes the operation of the main power switch.
Explains how to initiate a brew cycle using the start switch.
Operation of the switch for unsweetened or sweetened brews.
Routine cleaning steps for the brew funnel and sprayhead.
Weekly procedure to clean the sweetener delivery system.
Loading filter, tea leaves, and positioning funnel and server.
Steps to start and monitor the tea brewing process.
Diagnosing and resolving problems with the brew cycle not starting.
Identifying causes and solutions when water is not hot.
Troubleshooting issues preventing the dilution cycle from starting.
Addressing issues causing variable beverage levels in the dispenser.
Resolving problems with consistently high or low beverage levels.
Diagnosing spitting, excessive steaming, and dripping from the sprayhead.
Resolving problems related to continuous water flow into the tank.
Troubleshooting causes for the beverage overflowing the dispenser.
Addressing issues like weak beverage due to filter, tea, or water temperature.
Resolving issues where dry tea leaves remain in the funnel after brewing.
Identifying causes for the brewer making unexpected noises during operation.
Testing and replacing the brew solenoid valve.
Procedures for testing and replacing the early model brew timer.
Procedures for testing and replacing the late model digital brew timer.
Testing and replacing the control thermostat.
Testing and replacing the dilution solenoid valve.
Procedures for testing and replacing the dilution timer.
Testing and replacing the limit thermostat.
Testing and replacing the main ON/OFF or selector switch.
Testing and replacing the brew start switch.
Testing and replacing the optional sweetener solenoid valve.
Testing and replacing the tank heater element.
To Next Page
