To Next PageTo Next Page
Need help?Do you have a question about the Bunn VP17 and is the answer not in the manual?
General| Number of Warmers | 1 |
|---|---|
| Material | Stainless Steel |
| Power | 120V |
| Model | VP17 |
| Type | Pour-Over |
| Brewing Capacity | 3.8 gallons per hour |
Specifies 120V AC, 15A, single-phase, 60Hz service requirements for the brewer.
Details 100V AC, 20A, single-phase, 50Hz service requirements for "B" models.
Step-by-step guide for initial setup, including filling the tank and heating water.
Instructions for inserting filter, adding coffee, water, and completing the brew cycle.
Advises caution with electrical equipment, unplugging during service, and following procedures.
Addresses issues like no water or no power/incorrect voltage for the brew cycle.
Lists causes like tank heater switch, limit thermostat, or control thermostat for water not heating.
Lists causes like filter type, coffee grind, sprayhead, funnel loading, or water temperature.
Points to ON/OFF warmer switch or warmer elements for cool beverage serving temperature.
Instructions for testing the control thermostat's functionality using a voltmeter.
Step-by-step guide for removing and replacing the control thermostat.
