Combipad | 03-2020 Rev. 01 | English | 7
Configuration
Each step of a configuration is completed by the green LED flas-
hing twice. It is absolutely necessary to start the next confi-
guration step only after the green LED has flashed twice.
If the configuration step is not carried out correctly, the lock
signals this by flashing the red LED 8 times in quick succession.
Important: For the configuration of the Combipad Left version,
please note only the numbers written in brackets.
1
Select Mode
a)
Private Mode
Enter Master Code
1 (9) Master Code
Set mode
5 (5) 0 (0)
Note: To assign the private codes, please go to point
3a „Set the code“.
b)
Multi User Mode
Enter Master Code
1 (9) Master Code
Set mode
5 (5) 1 (9)
Note: After changing the mode, all functions are reset to the de-
fault settings. This does not apply to the Master Code.
2
Set the Code Length
Enter Master Code
1 (9) Master Code
Select number of digits
0 (0) x
4 digits: x = 4 (6)
6 digits: x = 6 (4)
Note: After changing the number of digits, all codes stored in
Private Mode are deleted.
3
Set Functions
Depending on the mode, certain functions are available for
configuration. Set the functions assigned to the mode according
to your requirements.
a)
Configuration in Private Mode
Set the code
Enter Master Code
1 (9) Master Code
Set code
3 (7) xxxx (xx)
Up to 50 private codes can be stored. Depending on the set
code length, these must be 4 or 6 digits long.
Delete the code
Enter Master Code
1 (9) Master Code
Delete code
9 (1) xxxx (xx)
Enter the code you want to delete.
Automatic locking
Enter Master Code
1 (9) Master Code
Activate
6 (4) 1 (9)
Deactivate
6 (4) 0 (0)
b)
Configuration in Multi User Mode
Code confirmation
Enter Master Code
1 (9) Master Code
Activate
2 (8) 1 (9)
Deactivate
2 (8) 0 (0)
c)
Set General Functions
Set own Master Code
Enter current Master Code
1 (9) Master Code
Enter new Master Code
7 (3) xxx xxx
Note: The Master Code must be 6 digits long.
LED locking indication
Enter Master Code
1 (9) Master Code
Activate
8 (2) 1 (9)
Deactivate
8 (2) 0 (0)
4
Reset to Default Settings
Enter General Code
4 (6) General Code
To Next Page
Loading...