To Next PageTo Next PageWhat to do if my Burndy Crimp tool won't stop running after releasing the trigger?
If your Burndy Crimp tool continues to run after you release the activation trigger, the trigger might be stuck or there may be a switch failure. First, remove the battery and check for contaminants around the trigger switch area. If the problem persists, remove the battery and return the tool to the factory for repair.
Why does the number of crimps per charge decrease with each recharge on my Burndy Crimp tool?
The number of crimps per charge might be decreasing because the battery is too warm from frequent discharge/recharge cycles. Allow the battery to cool to room temperature before recharging. It's also advisable to alternate batteries often.
What to do if the ram does not advance when activation trigger is pressed on my Burndy Crimp tool?
If the ram on your Burndy Crimp tool doesn't advance when you press the activation trigger, several issues could be the cause. First, ensure the battery is fully charged according to the battery charger instruction manual. Also, check if the ram release trigger/valve is being held open; if so, press and release it to reset the valve. If neither of these steps works, the pump or the activation trigger switch may be damaged, requiring a return to the factory for repair.
Why is my Burndy Crimp tool making excessive noise?
Excessive or unusual noise from your Burndy Crimp tool can be attributed to a few causes. It may be due to mechanical vibrations, in which case, the tool should be returned to the factory for repair. Another cause could be cavitation due to cold hydraulic fluid; if this is the case, allow the tool to warm up before use. Alternatively, cavitation could be due to hot hydraulic fluid; if so, allow the tool to cool before continuing use.
General| Brand | Burndy |
|---|---|
| Model | PATRIOT 81KFT Series |
| Category | Crimp tool |
| Language | English |
