To Next PageTo Next PageWhy won't the burners light on my Burns & Barkles Grill?
If the burners on your Burns & Barkles Grill won't light with the lighter system, there are several potential causes. First, the gas cylinder might be empty, in which case you should replace it with a full one. Second, the regulator could be defective; check it and replace it if needed. Finally, the burners, hoses, or nozzles might be blocked, requiring you to clean them.
What to do if there is a gas leak from the hose on my Burns & Barkles Grill?
If you notice a gas leak from the hose of your Burns & Barkles Grill, immediately turn off the gas at the gas cylinder. The cause is likely a damaged hose, which should be replaced.
What to do if Burns & Barkles 010392 has small flame or flashback?
A small flame or flashback (fire in the burner tube accompanied by a hissing noise) in your Burns & Barkles Grill can occur due to several reasons. The burner, hoses, or nozzles might be blocked, so cleaning them is recommended. Alternatively, strong wind could be the cause; try placing the grill in a sheltered location.
What to do if there is a gas leak from the gas cylinder of my Burns & Barkles Grill?
If you detect a gas leak from the gas cylinder of your Burns & Barkles Grill, immediately close the gas cylinder valve. The cause is likely a mechanical fault or damage.
General| Brand | Burns & Barkles |
|---|---|
| Model | 010392 |
| Category | Grill |
| Language | English |
