The sleeping time after each trigger.
Camera can be triggered by timer at a
preset time interval. Please note that even
in Time Lapse mode, the camera still can
be triggered unless the Sensitivity set to off.
The camera can be set to operate only at
specific time period. To enable this function
select ON and press ok. The start-stop
menu will then appear. This menu contains
the settings for times to start and stop as
well as the trigger interval and time lapse
interval. The start-stop setting will override
all other general camera settings. Since
there are 2 periods available, make sure to
not program times that overlap.
Enable or disable the PIR trigger and Time
lapse trigger by day of the week.
Make the camera working immediately.
Choose right timezone and press save.
Watermark in the left bottom corner of
image, up to 5 digits.
Could be written to exif info of photo.
To Next Page
Loading...