Bush BCH60B - Mounting Instructions

13
Installing your Cooker Hood
Bringing it all together
Installation requirements
THIS COOKER +22'0867%(,167$//('
%<$&203(7(173(562172/2&$/
5(*8/$7,216
Unpacking
Carefully unpack and examine the appliance for
any damage. If you think there is a defect, do not
use the appliance and contact Product Support
on 01759 487838.
Packaging materials should be collected
together and disposed of immediately as they
may be harmful to children.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Hood
3/($6(127(7KHFRRNHUKRRGPXVWEHLQVWDOOHGDWDPLQLPXPRIFPDERYHWKHKRE
or online at www.bush-support.com. If you still require further assistance, call one of our experts on 01759 487838.
Hood
Mounting Instructions
Ș Drill five 8 mm diameter holes to a depth of 50 mm for the
attachments and press in the wall plugs flush with the wall.
Installation
Ș Screw on the fixing bracket for the flue duct.
Ș Screw on brackets for the extractor hood hand-tight. Do not firmly tighten
the screws.
Preparing the installation Caution!
Ensure that there are no electric wires, gas or water pipes in
the area where holes are to be made.
● Mark a vertical centre line on the wall from the ceiling to the lower edge of the
extractor hood.
● Mark positions for the screws and the contour of the attachment
Installing your Cooker Hood
Bringing it all together