19
Using your DAB+/FM Radio
Let’s get started
DAB operation
Press Mode button to switch to DAB mode.
Full scan
1. Extend the telescopic antenna for the best reception possible.
2. Switch ON/OFF to on, and press Standby button to power up the DAB Radio.
3. A full scan will automatically commence when the unit is first switched on. The unit will
search for all available DAB stations. "
4. To start a scan manually, press Scan button or select Menu > Full scan. Once the scan is
completed, the radio will play the first station.
5. To view a full station list, press the MENU button and use the OK/Volume button to select
"Station List"
Manual tune
The manual tune menu option allows the user to select a particular channel and display the
signal strength for that channel.
Display modes and station Information in DAB Mode
Pruning stations
Time and Date: Displays the time and date information provided by the broadcaster.
Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
PTY (Program Type): Shows the type and description of the program provided by the DAB
station.
Channel and Frequency: Displays the station’s transmission channel number and frequency.
Signal Strength: Displays a signal bar with the strength of the current station.
Bit Error Rate (BER): Provides details of the signal error rate.
Bit Rate: The data rate at which the signal is being transmitted
When the DAB Radio has performed a scan in several locations you may find there are stored
stations that you can no longer receive. This function automatically removes them from the
stored station list.
1. Press the MENU button and use the dial to select Prune Invalid, then press the OK/Volume
button to confirm
2. Use the dial to select Yes, then press the OK/Volume button to confirm
To Next Page
Loading...