Product support
Help is always at hand
Troubleshooting
Not enough detergent
was dispensed.
Use more detergent, or change your
detergent.
Items are blocking the
movement of the spray
arms.
Rearrange the items so that the spray
can rotate freely.
The filter combination
is not clean or is not
correctly fitted in the base
of wash cabinet. This may
cause the spray arm jets
to get blocked.
Clean and/or fit the filter correctly.
Clean the spray arm jets.
Cloudiness on
glassware.
Combination of soft
water and too much
detergent.
Use less detergent if you have soft
water and select a shorter cycle to
wash the glassware and to get
them clean.
Possible Causes What To Do
Problem
The dishes
are not clean.
White spots
appear on dishes
and glasses.
Check water softener settings or fill
status of salt container.
Black or grey
marks on dishes
Aluminium utensils have
rubbed against dishes
Use a mild abrasive cleaner to
eliminate those marks.
Hard water area can
cause limescale
deposits.
Improper loading
Use gloves if detergent residue can
be found on dishes to avoid skin
irritations.
Dishes are removed
too soon
Do not empty your dishwasher
immediately after washing. Open
the door slightly so that the steam
can come out. Take out the dishes
until the inside temperature is safe
to touch. Unload the lower basket
first to prevent the dropping water
from the upper basket.
Detergent left in
dispenser
Dishes block
detergent dispenser
Re-loading the dishes properly.
The dishes aren't
drying
Product support
36
If you require any tec
hnical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
To Next Page
