5.10. Using combined detergents
These products should be used according to the
manufacturer’s instructions.
Never put combined detergents into the interior
section or the cutlery basket.
Combined detergents contain not only the detergent
but also rinse-aid, salt replacement substances and
additional components depending on the
combination.
We recommend you do not use combined
detergents in short programmes. Please use powder
detergents in such programmes.
If you encounter problems when using combined
detergents, please contact the detergent
manufacturer.
When you stop using combined detergents, make
sure that water hardness and rinse aid settings are
set to the correct level.
5.12. Filling the rinse -aid and setting
5.11. Rinse-aid usage
The rinse aid helps to dry the dishes without streaks
and stains. Rinse-aid is required for stain-free utensils
and clear glasses. The rinse aid is automatically
released during the hot rinse phase. If rinse aid
dosage setting set too low, whitish stains remains on
dishes and dishes do not dry and washed clean. If
rinse aid dosage setting set too height, you can see
bluish layers on glass and dishes.
When to refill the rinse aid ?
The regularity of the dispenser needing to be refilled
depends on how often dishes are washed and the
rinse aid setting used.
more rinse aid is needed.
Do not overfill the rinse aid dispenser.
3
Close the cap after all.
1
2
Remove the rinse
reservoir cap by lifting
up the handle .
Pour the rinse aid into
the dispenser, being
careful not to overfill.
1. Close the door and switch on the appliance.
2. Within 60 seconds after step 1, press the Program
button more than 5 seconds, and then press the Delay
button to enter the set model, the rinse
aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set
according to your using habits, the sets will change in the
following sequence: D1->D2->D3->D4->D5->D1. The
higher the number, the more rinse aid the dishwasher
uses.
4. Press the Power button to end the set up model.
The Low Rinse Aid indicator
(
) will be lit when
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse
aid, the dishwasher is designed to adjust the consumption
by user. Follow the below steps.
Using your Dishwasher
27
Using your Dishwasher
Getting the most from your appliance
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7
271.
NOTE:
The default setting is D3.
To Next Page
