The installation and repairing procedures should always carried out by the Authorised Service Agent in
order to avoid possible risks. The manufacturer shall not be held liable for damages that may arise
from procedures carried out by unauthorised persons. Repairs may be carried out by technicians only.
If a component has to be replaced, ensure that only original spare parts are used. Improper repairs or
use of non-original spare parts may cause considerable damage and put the user at considerable risk.
Contact information for your customer service can be found on the back of this document. Function-
relevant genuine spare parts according to the corresponding Ecodesign order can be obtained from
Customer Service for a period of 7-10 years, based on the type of component, from the date on which
your appliance was placed on the market within the European Economic Area.
WARNING
If there is a malfunction the dishwasher will display an error code. The following
table shows possible error codes and their causes.
Meanings
Longer inlet time.
Overflow.
Possible Causes
Some element of dishwasher leaks .
Faucets is not opened, or water intake is
restricted,or water pressure is too low.
Codes
E1
E4
Not reaching required
temperature.
Malfunction of heating element.
E3
Open circuit or break wiring for
the communication
Failure of communication
between main circuit board
and display circuit board.
Ed
If overflow occurs,turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,the water should be
removed before restarting the dishwasher.
If there is an error code that cannot be solved, please contact one of our experts on
0345 257 7271 for further assistance.
Product support
38
If you require any te
chnical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
AUTOMATIC FAULT WARNINGS AND WHAT TO DO
Product support
Help is always at hand
To Next Page
