Bush F841QW - Electrical Connections

6
EN
If you have damaged or missing parts,
call the Customer Helpline: 0345 257 7271
Any electrical work that
is required to install this
washing machine MUST
be carried out by a
qualified electrician.
Warning: THIS
APPLIANCE MUST BE
EARTHED
Before making any electrical connections, ensure
that:
-
mum power of the washing machine (fuses in the
power circuit must be 13 amp).
-
dicated in the technical specifications (page 17) and
the appliance rating plate (located where shown).
-
ance with the applicable law.

if the plug and socket are earthed. If necessary, an
additional earth cable should be attached to the
earth terminal on the back of the washing machine
and earthed.

easy reach.

extension cables are not recommended.

volt 50 cycle AC supply by means of a three pin
socket, suitably earthed and protected by a 13 amp
fuse.

fuse approved to BS1363/A must be used.

must be refitted when the fuse is replaced. If the
fuse cover is lost or damaged, the plug must not be
used until a replacement cover has been fitted or
the plug is replaced.

plug body as possible, the fuse should be removed
and the plug disposed of safely.

Should you need to replace the plug; the wires in
the power cable are coloured in the following way:
Blue – Neutral ‘N’
Brown – Live ‘L’

As the colours of the wires in the power cable may
not correspond with the coloured markings iden-
tifying the terminals in your plug, and proceed as
follows:

terminal in the plug that is marked with the letter E
or by the earth symbol.
The blue wire must be connected to the terminal
that is marked with the letter N.
The brown wire must be connected to the terminal
that is marked with the letter L.
If the power lead is damaged, it must be replaced
by a qualified electrician.
Installation