Using your Soundbar
Let’s get started
Using your Soundbar
22
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
5. Now that you have paired your device with the Soundbar, it will connect to it when it is
within range, which is about 10 metres or less (33 feet or less), line of sight.
6. Your device will remain paired with the Soundbar unless you decide to disconnect or
‘unpair’ it.
Note: You can press and hold the Bluetooth/Pair button on end of the Soundbar to
unpair your current device and search for new devices.
Controlling a paired device
Once paired you can either use the controls on the connected audio device to play/
pause, skip tracks etc., or you can use the control buttons on the Soundbar remote
control.
Play/Pause
Press and release to skip forward
Press and release to skip back
Line in mode
Check that your Soundbar is in Line in mode. If you are not already in Line in mode,
press and release the Source button on the Soundbar or the button on the remote
control to go to Line in mode. You will see a green LED on the front of the Soundbar.
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device.
2. Connect the other end to the Line in socket on the end of your Soundbar.
3. Press the Play button on your external device to start playback through the Soundbar.
4. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the Soundbar.
Note: It is recommended that you unplug the audio cable from the Line in socket on
the end of the Soundbar, after you have finished listening to your external device.
To Next Page
Loading...
