Using your Soundbar
Let’s get started
Using your Soundbar
23
section of these instructions, or online at www.bush-support.com. If you still require further assistance, call one of our experts on 0345 600 3021.
Optical mode
Check that your Soundbar is connected to the TV or other audio device using an Optical
cable (not supplied) and is in Optical mode.
If you are not already in Optical mode, press and release the Source button on the
Soundbar or the button on the remote control to go to Optical mode. You will see
an orange LED on the front of the Soundbar.
HDMI ARC Mode
Check that your Soundbar is connected to the TV using an HDMI cable (not supplied) and
that this is plugged into the HDMI ARC socket on the back of the Soundbar.
If you are not already in HDMI mode, press and release the Source button on the
Soundbar or the button on the remote control to go to HDMI mode. You will see a
purple LED on the front of the Soundbar
Note: Ensure that the HDMI ARC function is selected on your TV and the digital output
is set to PCM.
USB mode
Insert the USB stick which has the music files you wish to play, into the USB socket on the
end of the Soundbar. Check that you line up the USB stick with the USB socket and that it
is the right way around. When connected correctly you will see a white LED on the front
of the Soundbar
Note: Your Soundbar will support mp3, wma and wav audio formats.
You can use the remote control to play/pause and skip tracks on the USB.
Play/Pause
Press and release to skip forward
Press and release to skip back
To Next Page
Loading...
