original default setting for that parameter.
Field Scan (Time Lapse) not working properly
1. Make sure that the stop and start times of Field Scan "A" and "B" do not overlap
(for example, do not set the start time of "B" to 8AM if the stop time of "A" is 10AM).
CAUTION!: DO NOT USE the 1s Interval setting for Video at
night at a feeder or similar environment. It may cause the LEDs
to continue firing over a long period of time, which may overheat
and shorten the operating life of the internal electronic compo-
nents.
Do not mix old and new batteries.
Do not mix battery types-use ALL lithium or ALL alkaline.
Rechargeable batteries are not recommended.
To Next Page
Loading...
