Bushnell Sentry - Using the Mini Tripod; Using the Sliding Sun Shade

5
USINGtheMINITRIPOD
• Unfold the legs fully and set the tripod on
a stable, level surface such as a table or the
ground.
• Attach the scope by lining up the screw at
the top of the tripod with the 1/4”-20 socket
on the bottom of the scope’s tripod mounting
base, then turning the knob on the tripod until
the scope is securely attached to the tripod (do
not overtighten).
• To tilt or rotate (pan) the tripod head/attached
scope, twist the pan handle counter-clockwise,
move the head/scope to the desired position,
then tighten the pan handle (clockwise) to
hold it in place.
USINGtheSLIDINGSUNSHADE
If you experience glare or lens are due to the
angle and direction of the sun relative to the front
lens, pull the sun shade out to extend it.
SunShadeExtended
PanHandle
Legs
MountingKnob