MAINTENANCE
Your Bushnell
®
Trophy
®
Xtreme riflescope, though amazingly tough, is a precision instrument that deserves reasonably
cautious care.
1. When cleaning the lenses, first blow away any dry dirt and dust, or use a soft lens brush. Fingerprints and lubricants can
be wiped off with lens tissue, or a soft clean cloth, moistened with lens cleaning fluid.
WARNING: UNNECESSARY RUBBING OR USE OF A COARSE CLOTH MAY CAUSE PERMANENT
DAMAGE TO LENS COATINGS.
2. All moving parts of the scope are permanently lubricated. Do not try to lubricate them.
3. No maintenance is needed on the scope’s outer surface, except to occasionally wipe off dirt or fingerprints with a soft
cloth.
4. Use lens covers whenever it is convenient.
STORAGE
Avoid storing the scope in hot places, such as the passenger compartment of a vehicle on a hot day. The high temperature could
adversely affect the lubricants and sealants. A vehicle’s trunk, a gun cabinet or a closet is preferable. Never leave the scope
where direct sunlight can enter either the objective or the eyepiece lens. Damage may result from the concentration (burning
glass effect) of the sun’s rays.
ILLUMINATION ADJUSTMENT (Model 752515B only)
The DOA LR600i reticle in model# 752515B is illuminated. A brightness adjustment control is
provided at the end of the side focus knob, numbered from 1 to 6 with a “0” between each number.
(Fig. 1). To increase the brightness, set the control to a higher number (opposite the white side focus
index dot). To turn off the illumiination, and when storing the scope, set the dial at any “0”position.
Fig. 1
To Next Page
Loading...
