BuWizz 3.0 Pro - Page 42

CONFIDENTIAL
Moves your bricks. Fast. 42 UG_1.6 © 2021 BuWizz
suggested range for detection of
BuWizz is under 5 meters
2. Turn off BuWizz for 3 seconds
and try reconnecting
3. Restart the BuWizz app
4. In case the problem persists,
contact technical support
13
BuWizz works but at extremely low range
1. Contact technical support
Issue
N/A
14
My model loses connection when
accelerating, braking or reversing in high
speed/ludicrous mode
1. BuWizz's internal overcurrent
protection is tripping due to the
current spikes due to the fast speed
changes
2. Do not connect more than 2x XL,
2x L, 2x M or 1x RC or 1x BuWizz
motor per output
3. Use Ramp functions to set long
enough ramp-up time
4. Make sure to control motors
carefully, avoiding quick speed
changes and reversals of the power
sliders.
5. In cases where swift control and
reversals of motors are needed, use
Slow or Normal mode.
6. Run several BuWizz bricks in
parallel to increase number of
motors running in parallel for huge
models.
Issue
https://youtu.
be/UdWjysslE
e8
15
App connects to BuWizz, but after a while
model
stops responding
1. BuWizz will stop responding if
the model leaves the range - for
best performance keep your model
with 15 meters of range
2. Battery is empty - recharge
BuWizz
3.Under heavy load and drained
battery, BuWizz will reset itself and
terminate connection - recharge
BuWizz
Issue
N/A
16
BuWizz stops responding when control
device has not been used for a while
1. Check that BuWizz is still turned
on (BuWizz turns off automatically
if no commands are received for 10
minutes)
2. Exit the control profile and
reconnect to BuWizz
3. In case of connection issues
restart BuWizz or the app
Issue
N/A