BUXTON BTW 8200 - Putting into Operation

EN 9
Putting into Operation
Beforerstuse,besuretoreadthesafety
instructionscontainedinthisuser'smanual
carefully.
Beforeusingtheearphonesforthersttime,
removetheprotectivelmfromthecharging
contactsonthebottomoftheearphones
andreturnthemtothechargingcase.Start
chargingthechargingcaseandtheearphones
tothemaximumlevel.
Turning on the earphones –Takingthe
earphonesoutofthecasewillautomatically
switchthemon.Whentheearphonesarein
theo󰀨stateoutsidethechargingcase,press
andholdthetouchpadoneachearphone
andwaitfortheearphonetoannouncethe
“BUXTON”greeting.
Turningo󰀨theearphones–Inserting
theearphonesintothechargingcasewill
automaticallyturno󰀨theearphones.Long
pressandholdthetouchpaduntilthe
message“SEEYOU”isheardinunpaired
mode.