Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
3. After determining the position of the uprights,
mark center of the two holes in each upright base
on the trailer deck.
WARNING! Check under the trailer for locations
of brake lines and electrical wiring etc., before
drilling any holes. Any damage to trailer during
installation is installer’s full responsibility.
1 3004208 1 Post, Vertical Nonlocking, Trimmer Rack
2 0204300 2 Plug, Plastic Finish, 1" Sq Tube
3 3004083 6 Guide, Spring
4 3004084 6 Spring, Torsion Trimmer Rack
5 3005286 3 Hook, Grip Pivot
6 - 6 Screw, HHC 5/16-18 x 2-3/4" Gr 5 Zn
7 - 6 Nut, Nylock 5/16-18 Zn
8 3004091 1 Tube, Vertical, Locking, Welded
9 3004082 3 Hook, Pivot
10 3004090 1 Lock, Trimmer Rack, Finished
11 - 2 Washer, Flat 1/2" SAE Zn
12 - 2 Nut, Nylock 1/2-13 Zn
13 3004466 1 Angle, Top Connecting, LT10
14 - 14 Washer, Flat 3/8" USS Zn
15 - 4 Screw, HHC 3/8-16 x 2 Gr 5 Zp
16 - 4 Screw, HHC 3/8-16 x 2-1/2 Gr 5 Zp
17 - 8 Nut, Nylock 3/8-16 x 7/16 Zn
Installation Instructions
LT10 Lockable Trimmer Rack
for Utility Landscape Trailers
—continued on other side
Important!
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
Tools Required:
•Two 9/16" wrenches and/or sockets
•Electric drill
•13/32" drill bit
•Carpenter’s square
•Tape measure
•Two C-clamps
•Hack saw
CAUTION:
Always wear safety glasses when using power tools.
1. Clamp the locking and nonlocking uprights to
the trailer side rail approximately 28" to 34" apart
with the base of the upright on the trailer floor.
The locking upright may be assembled on the
left or right of the nonlocking upright. Verify the
uprights are square to the trailer deck in both
directions with a carpenter’s square. Note: If bent
shaft trimmers are used, the uprights need to be
mounted closer together than if straight shaft
trimmers are used.
2. Assemble a line trimmer to the rack to verify the
distance between the uprights is correct for the
model of trimmer you wish to hold. The large hook on
the nonlocking upright should engage the trimmer’s
grip and the smaller hook on the locking upright
should engage the shaft of the trimmer. Do not clamp
on or near the throttle trigger of the trimmer. With
the trimmer assembled in position, verify that the lock
assembly can rotate freely over the trimmer shaft.
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials
To Next Page
Need help?
General
