Buzzard Models AERONKISH User Manual (English)

To Next Page

AERONKISH

Made in the USA by

Buzzard Models LLC

Please read and understand all steps to these instructions before beginning assembly. This plane is not a toy and

is very dangerous to operate. Children should not operate this aircraft without adult supervision.

Before you start, it may be a good idea to gather the required items to complete this plane. You will need some

glue, elmers school glue and some 5 minute epoxy will work. You will also need a micro receiver minimum 3

channels, a 2s 7.4 volt 300mah 20c lipo battey, a battery charger, and a 3 channel transmitter.

Fuselage parts Locate fuselage sides, cabin top and two

5-1/8” bamboo rods

With cabin top temporarily in place, glue

bamboo rod to fuselage side alining

bottom with bottom of doubler.

Repeat on other side. Glue front and rear fuselage bottom. Find

F1, F2, and F3. glue into place. Make

sure slot in F1 faces forward.

Locate cabin floor and cabin top, glue

into place.

Locate landing gear leg and press into

slot.

With one fus. Side temporarily in place,

glue gear plate on with foam safe CA ,

epoxy, or white glue.

Using white school glue, glue both

fuselage sides, front fuselage top and

firewall into place. Start at front.

Need help?

Do you have a question about the Buzzard Models AERONKISH and is the answer not in the manual?

Buzzard Models AERONKISH Specifications

General

Brand	Buzzard Models
Model	AERONKISH
Category	Toy
Language	English

Summary

Fuselage Assembly and Preparation

Fuselage Bottom and F1-F3 Attachment

Landing Gear Leg and Gear Plate

Final Fuselage Section Gluing

Glue fuselage sides, front top, and firewall, starting from the front.

Aerodynamic Surfaces and Dihedral

Wing Root Gluing and Dihedral

Motor Mount and Firewall Installation

Mount the motor to the firewall using supplied screws.

Motor and Speed Controller Assembly

Assemble motor to speed control and install JST plug for battery connection.

Pushrod and Control Horn Installation

Insert pushrods into control horns and through fuselage holes; glue stabilizer.

Electronics, Controls, and Final Assembly

Servo and Receiver Installation

Install servos, attach receiver, and push wires through firewall.

Final Tail Surface Attachment

Wing Gluing and Wheel Installation

Control Throws and Center of Gravity

Adjust control throws and verify center of gravity for safe flight.

Buzzard Models AERONKISH User Manual