Why charging indicator on BW Technologies shows battery is still charging after 6 hours?
If the battery has been charging for 6 hours and the charging indicator on the LCD still shows the battery is charging on your BW Technologies detector, it means the battery is trickle charging. This indicates that the battery is fully charged and ready for operation.
What to do if battery indicator does not display when charging BW Technologies?
If the battery indicator does not display when charging your BW Technologies detector, it means the battery is depleted below normal levels. Charge the battery for 8 hours. If the battery indicator still does not light after charging, contact BW Technologies by Honeywell.
General| Operating Temperature | -20°C to 50°C (-4°F to 122°F) |
|---|---|
| Gas Detection | H2S, CO, O2, LEL |
| Measurement Ranges | 0-100% LEL |
| Resolution | H2S: 1 ppm CO: 1 ppm O2: 0.1% vol. LEL: 1% LEL |
| Alarms | Visual, audible, and vibrating alarms |
| Display | LCD |
| IP Rating | IP65 |
| Humidity | 0 to 95% non-condensing |
| Battery Type | Rechargeable lithium-ion battery |
Overview of the GasAlertQuattro detector and its purpose.
Essential safety guidelines, warnings, and precautions for detector use and handling.
Identifies common substances that can damage detector sensors and lead to malfunction.
Outlines initial setup steps and lists standard items included with the detector.
Details physical parts, screen icons, and button functions for user interaction.
Step-by-step guide on how to turn the detector on/off and understand the startup sequence.
Instructions for configuring detector-wide options like startup messages and modes.
Details how to configure individual sensor parameters, calibration, and alarm setpoints.
Explains various alarm types (Low, High, TWA, STEL, etc.) and their corresponding signals.
Covers how to stop alarms and view/clear recorded gas exposure data (TWA, STEL, Peak).
Details the process of bump testing sensors to ensure proper response to gases.
Step-by-step instructions for calibrating the detector's sensors using calibration gas.
Guidance on how to replace detector sensors and the sensor filter.
Provides solutions for common detector problems encountered during operation and startup.
Detailed troubleshooting for startup, calibration, and bump test issues.
Lists available replacement parts, accessories, and contact information for ordering.
To Next Page
