Why is the operating state indicator on my BWT Bewades RO3UV 50 Industrial Equipment red?
If the operating state indicator (illuminated b) on the front of the BWT Industrial Equipment housing lights up red, it means that maintenance is required, and wear parts need replacement. Perform the necessary maintenance, replace the worn parts, and then reset the digital running time meter.
What to do if there is water in the emitter casing tube of my BWT Bewades RO3UV 50?
If there is water in the emitter casing tube of your BWT Industrial Equipment, it is likely that water from the injector has entered the emitter casing tube through the air line. To resolve this, check if the check valve in the injector closes correctly. Clean the valve face, paying attention to the ball and pressure spring, and replace the injector if needed. Bleed the air line. Also, verify that the emitter casing tube is installed correctly, ensure the grey protective cap is positioned correctly, and replace the O-ring if necessary. Bleed the air line again.
General safety guidelines for operating the product safely to prevent damage or injury.
Specifies required qualifications for installation and servicing the unit.
Details specific safety warnings and measures for hazards like mains voltage, ozone, and UV rays.
Provides a guide to symbols used in the manual and their meanings.
Describes correct positioning, installation, operation, and maintenance for optimal performance.
Specifies requirements for installation location: protection, temperature, and load-bearing capacity.
Steps to prepare the unit for operation: water connection, electrical connection, and safety checks.
Instructions for programming and testing the digital running time meter for maintenance scheduling.
General| Brand | BWT |
|---|---|
| Model | Bewades RO3UV 50 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
