COSMY THE BOT | 100 | 150 | 200 | 250 | ROBOTIC POOL CLEANERS COSMY THE BOT | 100 | 150 | 200 | 250 | ROBOTIC POOL CLEANERS
English
Please use as much cable as
needed. Leave the remaining
cable out of the pool.
12 cm / 4.7 inch
above ground
3.6 m / 11.8 ft
Operation
Placement of the Power Supply
Place the power supply at least 3.6 meters / 11.8 feet from the
pool and at least 12 cm above ground. CAUTION: The power
supply is not water resistant; it must not be exposed to
water or to direct sunlight.
Press the plastic snap on the zip ties in order to release the
oating
cable. Use as much cable as needed in the the water.
Before placing the cleaner unit in the water
Make sure there are no people in the pool. Make sure that the
lters are clean. Make sure the pool conditions are met; (see
“Operating Conditions” ).
Placing cleaner in the water
Unroll the oating cable. It is recommended to extend a length of
cable that is equal to the pool diagonal size plus an additional two
meters. Smooth out coils or twists in the cable. Connect the
oating cable to the socket located on the power supply. Roll
extra cable, no in the pool, near the power supply. Place the
cleaner unit in the pool. Let it sink to the bottom of the pool. Do
not start operation before the robotic cleaner is settled on the
pool oor.
CAUTION: Operating the cleaner out of water may cause
immediate and severe damage resulting in loss of warranty.
NO SWIMMING
WHILE THE ROBOT
IS IN THE POOL
3
You may turn on
the cleaner when it
reaches the oor.
To Next Page
Loading...
Need help?
General
