7
English
RC60 ROBOTIC POOL CLEANER
Warning
Do not stay in the pool and remove
any and all items from the pool before
operating the robotic pool cleaner. Do
not leave the robot inside the pool if
unused.
The power supply must be connected
through a Ground Fault Current
Interrupter (GFCI USA) or a Residual
Current Device (RCD Europe) not
exceeding 30 mA.
The connection to the power must meet
local and national wiring rules.
All parts must be replaced with original
parts supplied by Aquatron Robotic
Technology.
Keep out of children's reach.
Do not use the robotic pool cleaner if
you have added liquid occulant or any
other clarier to the pool
water. These substances obstruct and
damage the robot lters.
CLEANER DOES NOT TURN ON
There is no electricity in the wall socket:
(1) Disconnect cleaner from the power and control unit.
(2) Disconnect power supply from the wall socket, wait
30 seconds and reconnect. (3) Turn power on. If not
activated, connect the unit to a different wall socket.
Obstacle in the drive system of the cleaner unit:
(1) Turn the cleaner unit carefully to view the underside.
(2) Check that the scrubbing brush is not bent/broken.
(3) Clean and remove obstacles and debris if necessary.
Propeller is seized due to accumulation of hair:
Check if the propeller is broken or needs to be cleaned.
CLEANER MOVES BUT DOES NOT PUMP WATER-
Filters are dirty: (1) Remove the lters (2) Run the robotic
cleaner in the pool without the lters. If working properly,
clean the lters well or replace the lters.
CLEANER PUMPS WATER BUT DOES NOT MOVE-
Obstacle in the drive system of the cleaner unit:
(1) Turn the cleaner unit carefully to view the underside.
(2) Check that the scrubbing brush is not bent/broken.
(3) Clean and remove obstacles and debris if necessary.
CLEANER STARTS AND SHUTS OFF AFTER A
SHORT TIME
Filters are dirty: (1) Remove the lters. (2) Run the robot-
ic cleaner without the lters. If working properly, clean
the lters well or replace the lters.
Propeller is broken or seized due to accumulation of
hair:
(1) Unscrew the outlet locker on the top outlet.
(2) Check if the propeller is broken or needs to be cleaned.
CLEANER DOES NOT PICK UP DIRT
Filters are dirty or have holes.
Clean as needed and verify that there are no holes
in the lters.
Propeller is broken or seized due to accumulation
of hair.
Check if the propeller is broken or needs cleaning.
The suction inlet is not close enough to the pool
oor.
Adjust the suction inlet.
CLEANER UNIT DOES NOT COVER THE ENTIRE
POOL
Clean the lters.
(1) Verify that there is enough length of the oating
cable in the water to reach the far end of the pool.
(2) Make sure that the oating cable is properly
spread out and is not tangled.
Propeller is broken or seized due to accumulation
of hair:
(1) Unscrew the outlet locker on the top outlet.
(2) Check if the propeller is broken or needs to be
cleaned.
THE CLEANER DOES NOT CLIMB WALLS
(1) Make sure to clean the lters
(2)
Check if the propeller is broken or needs to be
cleaned.
Troubleshooting
To Next Page
Loading...
