2020/10 - Indice de révision : D - Code : 25110CONSTRUCTION & RÉNOVATION
15/32
2.4 Only remove the support
• FIt the liner and insert 2 half pegs in the recesses in the mouth.
• Fill the pool with water
• The male section should be tted into both recesses.
To ensure this, before mounting the ange, cut the top part of the liner between the 2 recesses. Push the
male section into the recesses.
• Mount the ange and its seal.
• Cut the liner inside the skimmer mouth.
2.5 Finish
Insert the LinerLock tapping gently with a hammer around the entire periphery of the pool. The LinerLock must be
used to ensure perfect leaktightness at the point where the liner is tted into the locking track.
Purely cosmetic defects that may be found in areas that are concealed once the part is installed have no impact on
the mechanical strength or functionality of the product, and shall not be accepted as grounds for an exchange.
Hung cut out
Liner cut out
To Next Page
Loading...
