1. TOUCH CONTROL PANEL
HEAT
HEAT
PUMP
PUMP
AUTO
AUTO
AIR
AIR
SPA POWER
SPA POWER
AUTO LED:
This yellow LED lights up when the system is running in fully automatic mode. In this mode,
operation of the pump and the heater are automatically controlled to lter water and keep it at
the selected temperature.
PUMP LED:
This green LED lights up when the pump is running in AUTO or in MANUAL mode. The LED
ashes when the spa is in "standby" mode.
T
HEAT LED:
This red LED lights up when the heater is running in AUTO or in MANUAL mode. As a security
measure, operation of the heater is automatically regulated. To avoid the overconsumption
of electrical power which could damage the spa circuit boards, the system might not start the
heater when the blower is running or starts up.
Flashing of this LED indicates a system error (see paragraph 8)
AIR
AIR LED:
This LED lights up when the 'AIR' key is touched. It goes out when the key is pressed again. Note: the
LED will light up in this way even if the spa is not tted with a blower.
2. REGULATION OF THE WATER TEMPERATURE
In AUTO mode, the system automatically controls operation of the pump and the heater to lter the spa
water and keep it at the desired temperature selected by the user (the "set point", see below) so that it is
always ready for use.
2.1 Selection of the setpoint temperature by the user
The user may select a temperature between 10.0° and 41.5°C (in 0.5°C increments).
To do this,
• Kkeep the
key (shared with the underwater light – see paragraph 4) held down to increase
the temperature setpoint in 0.5°C increments.
• Keep the
key held down to decrease the temperature setpoint in 0.5°C increments.
Each 0.5°C temperature setpoint change is accompanied by a beep.
10/16
2020/10 - Indice de révision : A - Code : 37833 SPAS
To Next Page
Loading...