EasyManua.ls Logo

BYD L3 AUTO - Page 111

BYD L3 AUTO
202 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BYD L3 AUTO Owner’s Manual
Other Equipment 1-103
● Electric wire, rail fence, rope, etc.
●Cotton, snow and other materials
absorbing radio wave
●Objects with sharp edges and
corners;
●Low barrier;
●High barrier with its top part
extending towards your car;
● Objects under the bumper;
● Objects close to the car;
Persons nearby the car (subject to
type of clothes)
If the buzzer sounds, any barriers
may be detected by the sensor or the
sensor may be interfered by the
external environment. If this
phenomenon continues to exist, you
can contact BYD authorized service
station for repair.;
Parking imaging system
When the power supply is at ―ON‖ and
the gear lever on R, the system enters
Parking imaging mode
Reversing camera is installed behind
the back trunk door.
Sight range of the camera is limited.
Reversing video don’t display the
barriers close to the bumper corner
and under the bumper. Shown as
figure below:
Barriers close to the bumper corner.
Barriers under the bumper.
Operation of reverse
You can turn on the Parking imaging
system only when needing to reverse.
When gear lever on R, the touch
screen will display the reversing video
for driver observing the blind area to
help drive.
NOTE
Reverse safety line just provide to
refer while vehicle unloading
Reversing camera is installed behind
the back trunk door.

Table of Contents

Related product manuals