BYD L3 AUTO Owner’s Manual
To lay down the car, please rotate the
jack handle counterclockwise.
Please use a spanner for wheel bolt
to tighten the bolts. Do not use any
other tools or lever, like hammer, tube,
or your feet.
Make sure the spanner is fitted onto
the bolts firmly.
As per the order shown in the figure
above, tighten the bolts slightly one by
one, repeat the procedure until all the
bolts are fastened firmly.
● Please make sure no part of
your body and no one nearby
will get injured while laying
down the car onto the ground.
● When the tire is replaced,
please use the spanner with a
torque of 103N·m (10.5 kgf·m) to
fasten the bolts. Otherwise the
bolts will get loose, which may
cause the tire falling off and
result in serious accident.
After Tire Replacement
9. The tire pressure after
replacement.
Adjust the tire pressure to the value
specified in Chapter 8. If the current
pressure is lower than specified value,
please drive the car slowly to the
nearby service station for air
charging.
Do not forget to install the tire valve
cap, or dust and moisture will enter
the valve core to cause possible air
leakage. If the tire valve cap is
missing, please use a new one
immediately.
10. Put tools, jack and flat tire in
proper storage.
After tire replacement, please use a
torque spanner to tighten the wheel
bolts to the torque specified in
Chapter 8. The flat tire should be
repaired by a qualified technician.
Before driving, please make sure
all tools, jack, and flat tire are
fixed in their storage position so
as to reduce the possibility of
personal injury in case of a crash
or emergency braking.
If the Car Gets Stuck
If the car gets stuck in snow, mud, or
sand, please try to get it out by
pushing it forward or backward.
If there are persons or objects
near the car, please do not try to
move the car by pushing it
forward and backward. If not,
once the car gets out and
suddenly moves forward or
backward, there may be personal
injury or damage to objects.
To Next Page
Loading...
