EasyManua.ls Logo

BYD L3 AUTO - Page 126

BYD L3 AUTO
202 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BYD L3 AUTO Owner’s Manual
2-14 Tips on Driving BYD L3
(with deep anti-skidding tread) for
optimum operation performance.
In driving you shall check the
ever-changing road conditions. Damp
leaves my be as slippery as snow,
―Clean‖ road may be covered with thin
ice. When the environment
temperature is near freezing point,
driving is very dangerous as the road
may be covered by water and ice
alternatively. As a result, the adhesive
force may change a lot suddenly.
When downshift, take special care. If
the adhesive force is low, the driving
wheels may be locked up for an
instant, which may also cause
skidding.
In overtaking or being overtaken, take
special as the water fog splashed up
by large vehicle may block you view
and the air shock wave caused by
large vehicle may lead to losing
control of the car.
Note: do not drive on a road under
deep water, which may cause
damage or failure of engine and
electrical system.
Engine Fault Indicator
This indicator will be on for several
seconds when turning the ignition
switch to ON (II). If it turned on at any
other time, it means some emission
control device in the engine system
has fault. Even if you cannot feel
obvious change in vehicle
performance, the fault may cause
deteriorated fuel economy and
increase exhaust emission, and long
time driving under this condition may
result in severe damage.
Engine Fault
indicator

Table of Contents