2. Rotate the bulb anticlockwise to
remove it.
3. Pull off the ground wire and power
wire (If it is too tight, shake it first.),
and press down the buckle to remove
the bulb.
4. Replace the bulb.
The step of installation is opposite to
disassembly.
You need not to adjust the headlight
after replacing the bulb. In case that
you need to adjust the headlight,
please contact BYD service station.
High beam
1. Pull off the connector while
pressing down the buckle.
If the connector is too tight, shake it
first.
To Next Page
Loading...
