BYD L3 AUTO - Page 99

BYD L3 AUTO Owner’s Manual
Air Conditioning System 1-91
you shall close all the windows.
After closing all the windows, if
dusts raised by car still enter,
you are suggested to press the
internal and external recycle
button, set it to internal recycle
and turn the speed-regulating
knob of blower to non-0 gear.
Heating
To get best effect, set the panel of air
conditioner to the following:
Rotating speed of blower – non 0
gear
Temperature – point at warm (red
area)
Air suction – external recycle
(outside air)
Air flow -
Air conditioner - OFF
● To fast warm up, enable internal
recycle for several minutes. To not
fog on the windows, enable external
recycle after the car gets warmed.
● Press ―A/C‖ button to eliminate
moisture and warm up.
● When defrosting and defogging
for the windscreen, select air
flow to get the car warmed up.
Cooling
To get best effect, set the panel of air
conditioner to the following:
Rotating speed of blower – non 0
gear
Temperature – point at cold (blue
area)
Air suction – external recycle
(outside air)
Air flow –
Air conditioner - ON
To fast cool the car, turn the external
and internal recycle mode selecting
knob to internal recycle for several
minutes.
Ventilation
To get best effect, set the panel of air
conditioner to the following:
Rotating speed of blower – non 0
gear
Temperature – point at cold (blue
area)
Air suction – external recycle
(outside air)
Air flow –
Air conditioner - OFF
Defogging
Inside of windscreen
To get best effect, set the panel of air
conditioner to the following:
Rotating speed of blower – non 0
gear
Temperature – point at warm (red
area) to warm up;
Point at cold (blue area) to cool
down.
Air suction – external recycle
(outside air)
Air flow -
● In wet weather, do not blow the
cooling air to the windscreen –
indoor and outdoor temperature
difference may cause serious
fogging.
● To keep clear for front sight, rotate