Need help?Do you have a question about the C & K Systems ACTIVE 5 and is the answer not in the manual?
General| Brand | C & K Systems |
|---|---|
| Model | ACTIVE 5 |
| Category | Other |
| Language | English |
Introduces the Active 5 panel, its features, and planning considerations for installation.
Highlights features like non-volatile memory and zone isolation for false alarm prevention.
Details how to restore the panel to its factory default settings using a jumper link.
Step-by-step guide for physically mounting the alarm control panel securely.
Covers mains connection, battery connection, and detector circuit wiring.
Explains L+ connection for PIRs and using 'ID' output for detector reset.
Details the internal speaker and connections for external sounders and strobes.
Describes auxiliary power for detectors and wiring requirements for remote keypads.
Outlines three methods for setting the alarm system: Timed exit, Exit terminate, Door sense.
Information on using line fault terminals for the Active 5X comms version.
Describes various alarm outputs including relays, strobe, internal sounder, and trigger outputs.
Steps for powering up the panel, silencing sounders, and entering programming mode.
Methods to exit engineering mode, including automatic exit and manual exit.
Details the default engineer code and how to configure the full set bell delay.
How to program Exit Time, Entry Time, Bell Duration, and Night Set Exit Time.
Guide to programming zone types and attributes using the 4-X options.
A reference guide to programming zone types and applicable options using LEDs.
Meanings of zone types like Alarm, Entry Zones, 24 Hour, Fire, and PA zones.
Definitions for 24 Hour, Fire, Personal Attack, Home/Night Set isolate, Walk Through zones.
Explains Chime zones, Isolate Permit, and Bells & Strobe options.
Defines the Warning Tone option for a 24 hour zone.
A practical example demonstrating how to program Zone 1.
Instructions on how to access and review SET/UNSET events, alarms, and isolated zones.
Configuration options for Night Set and Home Set modes.
Settings related to engineer reset, PA alarms, and line fault detection.
Options specific to European standards, including LED flashing and auto-isolation.
Table detailing connections for various bellbox models to the Active 5 Panel.
To Next Page