C. Crane CC Solar Observer - Getting Started - Powering Your Radio; Power Using the Solar Panel; Power by Winding; Power Using AA Batteries

CC Solar Observer Page 9
Getting Started - Display Panel
AM Frequencies
FM Frequencies
Dynamo Indicator Light
Power Indicator Light
Note: Before powering your radio, be sure to read the Safety Instructions on
Page 4.
3RZHULQJWKH5DGLR
3RZHU8VLQJWKH6RODU3DQHOPlace the solar panel in direct sunlight. It is best
to angle the solar panel so that it is pointed directly at the sun. The solar panel is
hinged to allow for better positioning. Do not charge the radio in a hot area like
a car. To charge the internal battery pack with the solar panel, it is best to leave
WKHUDGLRWXUQHGRႇ(LJKWKRXUVRIGLUHFWVXQOLJKWVKRXOGSURYLGHWRKRXUV
of playtime at medium volume, depending on the sun intensity. Set the “Power
Switch” to “Dynamo” to play.
Power by Winding - Unfold the Dynamo Crank (labeled ‘Power Generator’) from
the side of the radio and rotate in either direction. The green “DYNAMO” light on
the front of the radio will glow indicating proper winding speed. After 90 seconds
of winding the radio will play for about 15 to 25 minutes. This varies depending
on the winding speed, volume level and band selection.
Power using “AA” Batteries - When using “AA” alkaline batteries the radio
should play at normal volume for about 60 hours. When using nickel metal
hydride rechargeable “AA” batteries, about 55 hours of play can be expected.
This radio will not charge user-installed batteries. Note: Do not use Lithium type
batteries.