Getting to know your
TM
SOFTSPEAKER 3
PLEASE READ INSTRUCTIONS AND SAVE THEM FOR FUTURE REFERENCE.
800-522-8863 ccrane.com
A
B
E
F
D
C
G
H
A
D
C
B
E
F
G
H
Power Button – Press briey to turn ‘ON’ the Amp for one hour. Extend time by
holding the power button longer: (1 light = 1 hour), (2 lights = 4 hours), (3 lights = 8 hours).
The sleep timer is always set to save batteries.
Indicator Lights – Briey lit to show sleep timer hours when POWER button is held and
battery life when BATTERY button is held. Middle light is always lit
to show when power ‘ON’.
Volume Control – Changes volume when dial is rotated.
Battery Tester – Press and hold to check battery life: (1 indicator light = 1% - 33%)
(2 lights = 34% - 66%), (3 lights = 67% - 100%)
TONE Switch – Changes tone between ‘Voice’ (up position) and ‘Music’
(down position). The ‘Voice’ setting is tuned for listening to audio books and
talk radio. The ‘Music’ setting provides full range audio with a boost but
consumes about 50% more power.
AMP Switch – Allows you to bypass the amplier when used without
batteries. The Volume control will still operate when AMP is o.
Batteries – Requires 2 AAA (Alkaline or NiMH) batteries. See battery
orientation in diagram on this page. Battery life is about 80 hours when
using the ‘Voice’ tone setting.
Battery Compartment Cover – Push indented arrow and slide down to remove cover.
To Next Page
Need help?
General
