C.P. Electronics EBDSPIR-PRM User Manual

Overview
The EBDSPIR-PRM PIR (passive infrared) presence
detector provides automatic control of lighting loads with
optional manual control.
The output channel comprises a mains voltage relay
capable of simple on/off switching.
Functioning as a presence detector, the unit can turn lights
on when a room is occupied and off when the room is
empty. Optional settings allow lights to be turned off in
response to ambient daylight.
All functionality is fully programmable using an IR handset.
Three variants are available.
EBDSPIR-PRM Ceiling PIR presence/absence
detector
EBDSPIR-PRM-IP Ceiling PIR presence/absence
detector sealed to IP55 when
installed flush in a ceiling.
EBDSPIR-PRM-IP-LT30 A special order version that can
be used down to -30ºC
Features
Front features
Back features
Ceiling PIR presence/absence detector
EBDSPIR-PRM, EBDSPIR-PRM-IP
Product Guide
PIR Sensor
Detects movement within the unit’s detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
The LED flashes Red to indicate the following:
Power Input & Switched Output Connector
Used to connect mains power to the unit and to connect a
switched load.
Switch Input Connector
Two input terminals can be used to manually override the
lights on or off.
Walk Test LED active
when movement is detected
Valid setting received
Retaining Spring
Retaining Spring
Power Input
& Switched
Output Connector
Switch Input
Connector
Sensor Lens
which covers...
PIR Sensor
IR Receiver
Light Level Sensor
Status LEDs
Mounting Bezel
EBDSPIR-PRM-IP-LT30
A special order version that can be used down to -30ºC

C.P. Electronics EBDSPIR-PRM Specifications

General

Brand	C.P. Electronics
Model	EBDSPIR-PRM
Category	Accessories
Language	English

Summary

Features

PIR Sensor

IR Receiver

Power Input & Switched Output Connector

Sensor Functionality

Detection Mode

Sets the unit to Presence or Absence mode for automatic lighting control.

Switch Level On/Off

Installation

Choosing a Suitable Location

Criteria for selecting an optimal mounting position for the sensor.

Absence Detection Setup

Procedure to switch between Presence and Absence detection modes.

Power-Up Test Procedure

Steps to verify the unit's functionality after power application.

Installation Methods & Details

Flush Fixing

Details the process for flush mounting the detector unit.

Surface Fixing

Details the process for surface mounting the detector unit.

Wire Stripping Details

Basic Programming

Button Activation

Walk Test

Time Out (Time Adjustment)

Sets how long lights stay on after movement ceases.

Lux On Level

Minimum light level to enable PIR sensor for switching lights on.

Lux Off Level

Maximum light level to disable PIR sensor, preventing lights from turning on.

Sensitivity

Adjusts the sensitivity level for detecting movement.

Presence / Absence Mode

Selects between Presence and Absence operating modes.

Fault Finding

Load Does Not Turn ON

Checks for live supply and load function if the light does not switch on.

Load Does Not Turn OFF

Ensures area is unoccupied and sensor placement is not near heat sources.

Advanced Programming

Detector Parameters

Switching Functions

Technical Data

Dimensions

Supply Voltage

Maximum Load

Temperature Range

IP Rating