Pic. 32
Pic. 35
CLEANING OPERATION
Pic. 33
How to remove and clean the tap components
1 - Pull out the pin for handle fixing (see
Pict. 32).
2 - Pull the handle from its place (see
Pict. 33).
3 - Unthread the main tap pin by pulling
it downwards (see Pict.34)
4 - Repeat the same operation for the
tap spring (see Pict. 35)
ATTENTION: Place all the components in a safe place in order to be sure they
are not lost.
NOTE: Do not use too hot water to clean the plastic components .
Clean the components with dish-washing soap and tepid water. Never use abrasive
cleaners.
Pic. 34
8
To Next Page
Loading...