CabanaCoast CB-20 - 2. Getting Started; Installation Considerations; Tools and Supplies Required; Appliance Inspection

2
Getting Started
—————————————————————————————————
Actiwin Company Limited disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged components.
• Modification of the burner assembly.
• Installation other than as instructed by Actiwin
Company Limited.
Any such action may cause a fire hazard
! WARNING
This appliance is a Decorative Gas Appliance for
OUTDOOR USE ONLY and MUST NOT be
used for cooking.
Place the CabanaCoast® Fire Pit on a flat and stable sur-
face in an outdoor location such as a patio or deck.
This location must be adjacent to the gas supply line or
LP gas supply cylinder. DO NOT locate the appli-
ance where it will get excessively wet or submerged in
water.
A. Design and Installation Considerations
When planning an appliance installation, it’s nec-
essary to determine the following information before
installing:
• Where will the appliance be installed? See section 3
• Gas supply piping. See section 4
• Framing and finishing details. See sections 3,7
B. Tools and Supplies Required
Before beginning the installation, be sure that the fol-
lowing tools and supplies are at hand.
• Gloves
• Safety Glasses
• Phillips screwdriver
• Non-corrosive leak-check soluon
• Wrenches
• 1 AAA baery
Asphyxiation Risk
• This gas appliance is for outdoor use in a well-
ventilated space.
• This unit must not be installed inside an enclosed
structure or unvented appliance
! WARNING
Do NOT use this appliance if any part of it has been
underwater. Have a qualified service technician in-
spect the appliance and replace any part of the control
system and any gas control which has been underwa-
ter.
! WARNING
Sharp Edges
Wear protecve gloves and safety glasses during installation
CAUTION
Do not burn solid fuels in this gas appliance
! WARNING
C. Inspect the Appliance and Components
Inspect appliance and components for damage.
Damaged parts may impair safe operaon.
• Do NOT install damaged, incomplete, or substute
components
! WARNING
• Carefully remove all burner components from pack-
aging.
• Read all instrucons before beginning installaon.
Follow these instrucons carefully during installaon
to ensure maximum safety and benet.
5