29
3
Settings of the loudspeakers outputs .
Press
to select between the 4 possible set-ups:
- 1 STEREO pair of loudspeakers (default mode). The SP1, SP2, STEREO LEDs are on.
- 2 STEREO pairs of loudspeakers. The SP1, SP2, SP3, SP4 and STEREO LEDs are on.
- 2 loudspeakers playing MONO. The SP1,SP2 and MONO LEDs are on.
- 4 loudspeakers playing MONO. The SP1,SP2, SP3,SP4 and MONO LEDs are on.
Before rst use, loosen the screw (PH00 screwdriver), remove the back cover, remove the battery
protection tab, replace the cover, retighten the screw.
Replacement of the CR-2025 type battery in the Stream remote control: loosen the screw, remove the
rear lid, remove the old battery and load the new battery properly with the "+" side on the clasp side,
put the rear cover back on, retighten the screw.
4
To Next Page
Loading...
