Cactus RF60X - Slave Flash Does Not Fire

57
4. Slave ash does not f ire
SYMPTOM POSSIBLE CAUSE SOLUTION
Flash Ready
LED blinks
or stays on,
b u t t h e  a s h
does not
f ire
Channel
mismatch
S e t Sl a v e  a s h t o
the same channel
a s t h e M a s t e r  a s h
Group mismatch Make sure the
group assigned to
t h e Sl a v e  a s h h a s
been activated on
t h e M a s t e r  a s h
Background
radio
interference
- Set all units to
another channel
or radio ID (see
Section 7.7)
- Change setup
location as
interference may
come from other
equipment in
the surrounding
area
Master and
Sl a v e  a s h e s
are placed too
close to each
other
Place the Master
a n d S l a v e  a s h e s
at least 20cm
apart and retry
Beyond 100m
effective
range
- Make sure the
Master and Slave
 a s h e s a r e
placed within
100m (328ft) of
each other
Note:
The effective
range of 100m
(328ft) may not be
achieved in the
presence of radio
interference