Cadac 5431 - Operating the Appliance; Parts List

To Next Page

To Previous Page

Fig. 2

4. Operating the Appliance

• Always operate the appliance on a rm level surface.

• To light the appliance, hold a ame to the burner, turn the gas control knob (N) (Fig. 2) slowly in the direction of the “+” arrow

(anti-clockwise) until gas ignites.

• After lighting, do not move the appliance around as liquid gas may enter the appliance from the gas cylinder, causing large yellow

ames.

• Adjust the size of the ame by turning the control knob (N)(Fig. 2). To increase the size of the ame, turn the knob anti-clockwise

and to decrease turn the knob clockwise.

• After use, always ensure that the control knob is turned to the “off” position (turn fully clockwise).

• In the event of light-back (ignition inside the burner (A) or mixing tube), do not move the cylinder but simply turn the gas control

knob fully clockwise. Wait until all the ames are extinguished. Follow the safety instructions given in sections 2, 3 and 6. Re-light

the appliance.

PARTS LIST

A BURNER

B SECURING SCREWS

C COOKER PLATE

D POT STAND

E WASHER

F ADAPTOR

G AIR HOLES

H RUBBER SEAL

I BRASS INSERT

J MESH

K JET

L FILTER

M CYLINDER (not supplied)

N CONTROL KNOB (not supplied)