To Next PageTo Next PageWhy Cadet Lawn Mower will not mulch grass?
If your Cadet Lawn Mower is not mulching grass properly, place the throttle in the FAST position. Avoid mowing when the grass is wet, and wait until it's drier. Try mowing at a high cutting height first, then mow again at the desired height, or use a narrower cutting swath. Also, ensure the blade is sharp; sharpen or replace it if necessary.
Why is my Cadet 1170 engine overheats?
If your Cadet Lawn Mower engine overheats, ensure the crankcase is filled with the proper capacity and weight of oil. Also, clean any grass clippings and debris from around the engine’s cooling fins and blower housing.
What causes excessive vibration in Cadet Lawn Mower?
To address excessive vibration in your Cadet Lawn Mower, start by tightening the blade and spindle. If the vibration persists, balance the blade. If neither of these steps resolves the issue, replace the blade.
General| Brand | Cadet |
|---|---|
| Model | 1170 |
| Category | Lawn Mower |
| Language | English |
Follow all instructions for safe operation, keep manual handy, use responsibly.
Operate carefully on slopes, mow up/down, avoid sudden turns, observe limits.
Keep children away, be alert, never carry children, age restrictions.
Handle fuel with care, use approved containers, proper refueling procedures.
Connect battery cables correctly, ensuring positive and negative terminals are properly attached.
Service engine with gasoline and oil as instructed, check oil level before operating.
Ignition switch, choke, throttle, PTO, lift, drive, and brake controls.
Parking brake, shift lever, cruise control, seat adjustment, and cup holder.
Prevents starting or operation under unsafe conditions for operator protection.
Procedures for starting the engine, driving, and stopping the tractor.
Setting cutting height, cruise control, driving on slopes, and headlights.
Adjusts the cutting deck for even grass cutting, front-to-rear and side-to-side.
How to adjust the seat position for operator comfort and safety.
How to adjust steering links for turning consistency or after part replacement.
Procedures and warnings for adjusting the engine carburetor and brakes.
Engine maintenance includes checking oil, filters, and spark plugs.
Instructions for cleaning the tractor and safely removing the cutting deck.
Steps for changing deck and transmission drive belts.
Information on cutting blades and battery maintenance.
Procedure for charging the battery and recommended tire pressure.
Lubrication points for engine, pivot points, linkage, steering gear, wheels, axles, and spindles.
Instructions for obtaining warranty service, including dealer location and contact info.
Cases not covered by warranty, implied warranties, and liability limitations.
Explanation of how state law grants specific legal rights related to the warranty.
