2-43
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
D
Turn and Lane
-Change Signals
D
Headlamp High/Low
-Beam Changer
D
Flash
-To-Pass Feature
D
Windshield Wipers
D
Windshield Washer
For more information on the exterior lamps, see
“Exterior Lamps” later in this section.
Turn and Lane-Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the turn is complete.
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it’s released.
If the turn signal is left on, a warning chime will sound
and the Driver Information Center (DIC) will display
TURN SIGNAL ON after driving about a mile to
remind you to turn it off.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned out signal bulb.
Other drivers won’t see the turn signal.
Replace burned
-out bulbs to help avoid possible
accidents. Check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned
-out bulbs if the
arrow fails to work when signaling a turn.
To Next Page
Loading...
Need help?
General
