1-3
Massaging Lumbar (If Equipped)
This control is located
on the outboard sides of
the front seats. With the
ignition on, briefly press
the top of the control where
it is marked AUTO to
activate the massaging
lumbar feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by briefly pressing
the bottom of the control. The lumbar support can be
adjusted during the massage cycle by moving the control
forward to increase support and rearward to decrease
support. The massage cycle will continue to run even if
the ignition is turned to OFF, unless interrupted.
Four-Way Rear Power Lumbar
(If Equipped)
Four-way lumbar support, without the massage feature,
is also available for the outboard rear seating positions.
If your vehicle has this
feature, the rear lumbar
support controls are located
on the rear door trim panels.
To activate the rear lumbar support feature, push
forward on the control to increase support or rearward to
decrease support. The lumbar control can also be moved
up and down to adjust the location of the support.
To Next Page
Loading...
Need help?
General
