Flash-to-Pass
This feature allows you to use the high-beam
headlamps to signal the driver in front of you that
you want to pass.
Pull and hold the turn signal/multifunction lever toward
you to use this feature. When you do, the following
will occur:
• If the headlamps are off, in low-beam or in
Daytime Running Lamps (DRL) mode, the
high-beam headlamps will turn on. They’ll stay
on as long as you hold the lever there. Release
the lever to turn them off.
• If the headlamps are in high-beam mode, they
will switch to low beam. To return to high-beam,
push the lever away from you.
Windshield Wipers
The lever on the right side of the steering column
operates the windshield wipers.
7 (Mist): Pull the lever down and release it for a
single wiping cycle. The lever will return to its original
position. For more cycles, hold the lever down before
releasing it.
9 (Off): Put the lever in this position to turn off the
wipers.
& (Delay): Put the lever in this position to set a delay
between wipes. Turn the delay adjustment band to
set the length of the delay.
x (Delay Adjustment): Use this band to set the
length of the delay between wipes when using the delay
feature. The closer you move the band toward mist,
the longer the delay. The windshield wiper lever must be
in delay for this feature to work.
3-9
To Next Page
Loading...
